J5I Series 33~43dBm High Power Outdoor Industrial Repeater
Introduction
Signalwing’s J5I series are designed for outdoor application. It’s able to support any two of the popular mobile systems, such as GSM, CDMA, WCDMA, LTE or TETRA etc. It helps the consumers to improve the cellular coverage in villages, supermarket, large residential buildings which are suffering the poor signal reception.
There is a outdoor housing which can keep away from water and rains. Built-in ALC circuit to prevent any interference or damage to the devices and BTS. The coverage of J4Iis ranging from 3000~6000 square meters due to different power level and input signal strength.

Product Features
1 | Superb linear performance |
2 | High output power with water-resist housing |
3 | Designed for outdoor application |
4 | Automatic gain control and manual gain control |
5 | Easy installation & maintenance |
6 | Extend cell phone battery life |
Parameters |
Uplink |
Downlink |
|
Frequency Range (Accept customize one or two or three different bands combination) | Dual band | ||
Max. Gain | J5I-33 |
≥80dB |
≥85dB |
J5I-37 |
≥85dB |
≥90dB |
|
J5I-40 |
≥85dB |
≥90dB |
|
J5I-43 |
≥90dB |
≥95dB |
|
Max. Output Power |
J5I-33 |
25dBm |
33dBm |
J5I-37 |
27dBm |
37dBm |
|
J5I-40 |
30dBm |
40dBm |
|
J5I-43 |
33dBm |
43dBm |
|
Band Width | various bandwidth is available upon request | ||
Manual Gain Control | 31dB in step of 1dB | ||
Maximum Input Power(non-destructive) | 0dBm(CW Signal) | ||
Out of Band Gain | Fully comply with 3GPP 36.106 | ||
Operating band unwanted emissions | Fully Comply with 3GPP TS 36.106 | ||
Spurious Emission | Fully comply with 3GPP 36.106 | ||
Input Intermodulation | Comply with 3GPP | ||
Output Intermodulation | Comply with 3GPP | ||
AGC (Automatic Gain Control) | ≧25dB | ||
Gain Flatness | ≦8dB(P-P) | ||
Spurious Emission | 9KHz~1GHz | ≦ -36dBm | |
1GHz~12.75GHz | ≦ -30dBm | ||
Error Vector Magnitude | ≦ 10% | ||
Noise Figure | ≤ 6dB | ||
VSWR | ≦2.0 | ||
Return Loss | ≦-10dB | ||
Group Delay | ≤5μs | ||
Frequency stability | ≤ 0.01ppm | ||
Alarm | Power, ALC alarm display on the LED screen | ||
RF Connector | N-Female | ||
Impedance | 50Ω | ||
Power Consumption | 80W | ||
Power Supply | AC:110~240V;50/ 60 Hz | ||
Operating Temperature | -25℃~50℃ | ||
Environment Conditions | IP65 | ||
Dimensions (D x W x H ) | 453.6*357.8*159.7 mm | ||
Weight | ≤22kg | ||
Monotoring | Support local control or Remote Control |